Skip to content
Guide-ID Help Center

Replacing IDentifier batteries

1 min readUpdated Nov 202610 steps

This page shows how to replace the batteries of an IDentifier. After a year or two indoors, an IDentifier’s battery runs out. Both the IDentifier V2 and the IDentifier V3 use 2 × CR2032 lithium coin cells. The steps depend on the model.

IDentifier V3

Section titled “IDentifier V3”
  1. Remove the front label with a fine, small knife.
  2. Remove the 4 screws with a T6 screwdriver.
  3. Remove the top cover. Keep the seal in the front part.
  4. Carefully take out the circuit board with the transmitter and batteries.
  5. Replace the 2 CR2032 coin cells.
  6. Reassemble the IDentifier.

Instruction sheet IDentifier V3 battery (PDF)

IDentifier V2

Section titled “IDentifier V2”
  1. Remove the front with a fine flat screwdriver.
  2. Carefully take out the circuit board with the transmitter and batteries.
  3. Replace the 2 CR2032 coin cells.
  4. Reassemble the IDentifier.

Instruction sheet IDentifier V2 battery (PDF)

Section titled “Related articles”
Was this article helpful?